Hello & Welcome back to #FabulousFriday! If you are thinking about listing your home, you might need to consider curb appeal. One of the best ways to create an attractive first impression is a beautiful lawn. Here are some tips and tricks for refreshing your yard:
Tips for Planting a Lawn
Whether you’ve just moved in to a brand new house with a barren, dusty yard or have lived with a less-than-satisfactory lawn for years, now’s the perfect time to plant anew. The task may seem daunting, but seeding is easier than you ever imagined, and the least expensive option to provide you with the lush, even lawn you’ve always dreamed of.
Sod should be laid in the fall or spring in the North and in the spring in the South. You should plant sod during cool, humid weather as dry hot weather will cause the sod to burn out. And don’t lay sod later than one month before the first fall frost so it can establish roots before cold weather sets in. Sod is sold by the square foot or square yard, and you’ll pay about 15 to 35 cents per square foot. You can save 30-50 percent more by installing it yourself. The most expensive sods are slow-growing, speciality gasses like buffalo grass and bentgrass, which can cost up to $1.10 per square foot.
Before you buy the sod, till your soil four to six inches deep, checking with your utility companies to make sure you don’t damage lines. Remove all debris and large rocks. Water the soil to make it moist but not muddy. Sod should be laid no more than 24 hours after it has been cut at the farm, because the rolled sod will heat up and begin to biodegrade. Inspect the sod when it’s delivered before the truck leaves to make sure it’s in good shape. Shake it to make sure it doesn’t fall apart or is degrading already.
Ask the truck driver to help you place the sod pallets near where you will be planting. Start by laying the sod along the longest straight line next to your lawn, a sideway, patio or driveway. As you lay the sod, butt and push the sod’s edges and ends against each other tightly without stretching. Stagger the joints in each row like bricks and avoid gaps or overlaps. On sloping areas, place the turf pieces across the slope.
Use a large knife to trim corners and avoid leaving small strips at the outer edges as they will dry out and die. Stay off the sod as much as possible to prevent indentations and air pockets. After installation, roll the entire area with a lawn roller, available to rent, one-third full of water to press the sod roots into contact with the soil. Start watering within 30 minutes of installation, thoroughly wetting grass until it soaks through into the underlying soil. To check penetration, lift a corner of the sod. If it isn’t soaked, keep watering. Once the water begins to run off, turn sprinklers off and let the water soak in. Then water again. Repeat for the next two to three weeks. To test for sufficient moisture, puncture the soil with a screwdriver. If it penetrates easily, your lawn is in good shape; if there’s resistance, keep watering.
If you are thinking of listing your home--we are here to help. Please contact us today and one of our helpful friendly Shaffer agents will be in contact right away. See you next Friday! Warmly, Susan